The operation of pneumatic tools

The operation of pneumatic tools
1, the gas supply
(1) with 90 psi (6.2 Bar) is clean and dry air supply. High pressure will quickly reduce the tool life.
(2) with tools chart along with the appropriate size of the parts, tube and hose connection tools.
(3) if you use the air pressure regulator, set the air pressure in the output pressure of 0.62 MPA.
2, steps,
(1) the pneumatic tools connected to the air line.
(2) set the air pressure.
(3) the air line must be set lubricating device, lubricating device if the air is not up to standard or not, shall be given to the following maintenance tools:
A. work continuously 3 to 4 hours later, the tool is separated from gas source, from the air inlet into the 7-8 drops high purity light oil (low viscosity), connecting the trachea, open source, the oil into the cylinder. Conditional users and work intensity is at full capacity, it is suggested that the intake with cadger joint.
B. usually 30 to 40 days need on a regular basis on air compressor and oil-water separator drainage, impurities and maintenance, to ensure the clean and dry air of into the tool.